The adjustable HID electronic ballast VGT stands out for its high quality and the most stable on the market of horticulture and hydroponics . The electronic ballast can be used with both metal halide bulbs ( MH ) and with high pressure sodium (HPS ) . It incorporates an adjustable switch that adjusts the output power from 250w to 700w with discretionary accruals .
Specifications Solid Power 600w dimmable electronic ballast
Input Voltage Range : 220-240 V
3.4 A @ 220V, 700W
Fastor power greater than 0.99
THD . less than 10%
Operating temperature: -30 º C to 50 º C
Output Frequency: Greater than or equal to 35 KHz
Works for Lamps MH and HPS .
Works with lamps up to 25 m away.
Water Protection : IP65
Features adjustable ballast 600w VGT
Adjustable switch lets you select the desired exact power .
His constant output power and security system verification only guarantee the operation of the ballast an excellent and safe way.
Higher luminous flux : Exceeding 15 % higher lumen output , higher lumen equals more production.
Supremely control function , the ballast VGT offers performance unsurpassed performance . The adjustable switch lets you select the exact desired power regulation made smoothly without jumping or sudden drops in power . This feature can significantly extend the life of the lamp. You can use all kinds of bulbs Sodium HPS and MH simply selecting the console control panel by two power buttons , after selecting the power in the ballast would connect the correct bulb .
By adjusting 700w output results in a higher output 15% more than the 600w setting .
In other words : Increased production of lumens = more light = more yield per harvest.
random start
The ballast will be delayed between 1 and 3 seconds each time before starting. This dramatically reduces current spikes and allows for initial energy consumption but less intense when a ballast is used in the same field.
MCU : Self Diagnosis System
The micro controller self-diagnosis system uses inverter to provide maximum energy savings , reliability and smooth operation technology.
Works with MH and HPS lamps provided they are of the same power rating . Our own self-diagnostics electronics market takes to check the input voltage , current and lamp conditions to provide optimum performance.
The electronic ballast automatically operate with input power from 220 to 240 volts 50/60 Hz Output has a protective function of open circuit and short circuit. The diagnostic functions disconnect the ballast in case of damage or failure of the lamp .
The LED indicator allows the user to diagnose any problem and to avoid any possible problems due to equipment failure .
Control anti - interference
The electronic ballast passes EMC to avoid interference from RF ( Radio Frequency ) with the environment while running this is very important because it prevents to be detected by electromagnetic interference producing electronic ballasts that can distort any signal to radio, television , etc ...
What is included :
1x adjustable HID Electronic Ballast
1x User Manual
1x Power cord with European 220V input
Instructions:
Place the reflector in a suitable place and screw the bulb in the reflector thread . Ballast Keep away from sources of heat and moisture to prevent premature failure.
Connect the output cable to the lamp .
Connect the power cord to the power socket, the ballast
Select the output power from 250w to 700w discretion .
Plug the cord into the power supply .
IMPORTANT safety measures
Do not operate the machine in areas with mixtures of gases and corrosive or explosive air.
In case of malfunction, disconnect the computer from the network. With the appropriate security measures , disconnect the input jack .
Ensure that children are kept away from the ballast.
Do not use electronic ballast wires to hold or place on sharp edges.